Garmin G1000 Mooney M20TN - Manual (Page 77)

190-00647-00 Rev. A Garmin G1000 Pilot’s Guide for the Mooney M20M/M20R/M20TN 3-7
EIS
3.4 SYSTEM DISPLAY
NOTE: Fuel calculations do not use the aircraft Fuel Quantity Indicator and are calculated from the last time
the fuel was reset.
NOTE: If any parameters are exceeded, the system automatically switches back to the Engine Display.
The System Display is accessed by pressing the ENGINE Softkey followed by the SYSTEM Softkey. Engine
hours and fuel calculations (fuel flow and fuel remaining) are shown in the System Display. Beneath the gauges
and Fuel Quantity Indicator, fuel pressure is displayed for the M20M only. EGT (M20R only) and TIT (M20TN
only) are shown below the fuel calculations grouping. The electrical and trim groups are also shown.
Accessing the EIS System Display:
1) Press the ENGINE Softkey.
2) Press the SYSTEM Softkey.
3) To return to the default Engine Display, press the ENGINE or BACK Softkey.
Fuel calculations are based on the fuel flow totalizer and the displayed fuel remaining, adjusted by the pilot
using the following softkeys:
• DEC FUEL – Decreases totalizer-based fuel remaining in one-gallon increments
• INC FUEL – Increases totalizer-based fuel remaining in one-gallon increments
• RST FUEL – Resets totalizer-based fuel remaining to the aircraft’s fuel capacity
Adjusting the fuel totalizer quantity:
From the System Display, press the DEC FUEL or INC FUEL Softkey to obtain the desired number of gallons
remaining (GAL REM).
Resetting the fuel totalizer:
From the System Display, press the RST FUEL Softkey. This also resets the displayed fuel remaining (GAL REM)
to zero.