QNAP Security VioStor NVR (Version: 3.3.2) User Manual
Page 218
218
To allow a remote PC to connect to the VioStor and the IP cameras, you need to:
Step 1. Set up the port mapping (virtual server) on the router.
From Forward
to
219.87.144.205:8000 192.168.1.1:80
219.87.144.205:8001 192.168.1.101:80
219.87.144.205:8002 192.168.1.102:80
219.87.144.205:8003 192.168.1.103:80
Step 2. Add the IP camera to the VioStor by entering the IP address of the IP camera in
the ‘IP Address’ settings. Enter the public IP address of the router and the mapped ports
of the IP camera in the ‘WAN IP Address’ settings.
Note:
When configuring the IP camera, the WAN IP and LAN IP must be entered.
To open FTP (port 21) and SMB (port 445) of the VioStor on WAN, configure the following
port mapping settings:
From Forward
to
219.87.144.205:21 192.168.1.1:21
219.87.144.205:139 192.168.1.1:139
219.87.144.205:445 192.168.1.1:445
After finishing the above two steps, you can connect to the VioStor on WAN by entering the
IP address http://219.87.144.205:8000 in the IE browser. Then login the VioStor with the
correct user name and password.
If the port specified to the VioStor is 80, you can enter http://219.87.144.205 to connect to
the VioStor.
Note:
If the router does not use a fixed IP, you will need to configure the DDNS settings on
the router. Other configurations are the same as above.