Grain Systems Bin Accessories PNEG-1451 User Manual
Page 24
5. 2.66" Corrugated Commercial Hopper Tank 4-9 Rings
24
PNEG-1451 Ladder, Safety Cage and Platform for Hopper Tanks
Eave Starter Bracket and Ladder Assembly with Safety Cage
Once the two (2) 3/8" holes have been field drilled, attach the starter brackets to the sidewall as shown in
. Check the top ladder section to make sure the ladder rung dimples are to the top. Attach starter
brackets to the top of the ladder.
for the proper installation of additional ladder
sections required. Standoff brackets must be installed on the ladder sections and attached to the sidewall
at each horizontal seam and repeated every 32". Use 5/16" x 3/4" bin bolts for all connections. It is also
necessary to field drill a 3/8" hole on the ladder section for each starter bracket (L.H. and R.H.).
Figure 5C
NOTE: Refer to general detail information
for additional details for standoff bracket to ladder
assembly and also, 8' extension rail installation (omitted in detailed figure above for clarity).