Grain Systems Bin Accessories PNEG-1451 - Manual (Page 98)

8. 4.00" Corrugation Farm Commercial Hopper Tank (FCHT) 7-9 Rings
98 PNEG-1451 Ladder, Safety Cage and Platform for Hopper Tanks
Access Door/Base Safety Cage Hoop Assembly
Before attaching any pieces to the ladder or platform, some pre-assembly is required. Attach the safety
cage brackets to the ladder section. (See general detail information
on Page 12 for proper installation
instructions). Bolt the safety cage hoop adjuster plates onto the extension angle as shown in Figure 8Y .
For the middle hoop assembly, bolt the safety cage hoop adapters and safety cage hoop half together using
the proper holes, based upon the bin diameter.
(See Page 90.) Be sure to use the 5/16" x 3/4" bolt with the
head of the bolt to the inside of the safety cage. Bolt this assembly to the safety cage bracket and hoop
adjuster plate, tighten as you go. Use the safety cage hoop adjuster angle to secure the two (2) hoop half
assemblies to the vertical entrance angle on the platform assembly. To finish the installation, secure the
bottom hoop assembly to the vertical entrance angle on the platform assembly.
Figure 8Y
Cage hoop bracket
(See general detail
information
on Page 12
for assembly details.)
Extension angle (LS-6775)
(See general detail
information
on Page 12
for proper installation.)