24"-48" safety cage bell sections, And 79 – Grain Systems Bin Accessories PNEG-1451 User Manual

Page 79

Advertising
background image

7. 4.00" Corrugation Farm Commercial Hopper Tanks (FCHT) 4-6 Rings

PNEG-1451 Ladder, Safety Cage and Platform for Hopper Tanks

79

24"-48" Safety Cage Bell Sections

Attach the vertical supports to the hoop half assembly from the safety cage installation using 5/16" x 3/4"
bolts and nuts (with the heads on the inside of the cage). Assemble the special bell safety cage hoop
halves and attach to other end of vertical supports. The vertical supports will have to be bent at the flat
area to allow for the angle of the bell section. Attach the safety cage brackets to the ladder as shown in
the general detail information

on Page 12

. Once the safety cage brackets are installed, attach the bell

safety cage hoop half assembly to the safety cage brackets and tighten bolts.

NOTE: The safety cage bell section is to be used at the point of termination of the safety cage and should

be just above the concrete (generally 7' to 8').

Figure 7U 24" Bell

Figure 7V 48" Bell

Advertising