Grain Systems Bin Accessories PNEG-1451 - Manual (Page 89)

8. 4.00" Corrugation Farm Commercial Hopper Tank (FCHT) 7-9 Rings
PNEG-1451 Ladder, Safety Cage and Platform for Hopper Tanks 89
Eave Safety Cage Hoop Assembly
Before attaching any pieces to the ladders or platform, some pre-assembly is required. Attach two (2)
safety cage brackets to the 8' extension rail and one safety cage bracket to the second 4' ladder section
as shown in
Figure 8K . ( See Page 48 for assembly details.) Bolt the safety cage hoop adjuster plates onto
the extension angle as shown in Figure 8K . Using the proper configuration depending on the bin diameter
(see adapter assembly detail on Page 90 ), bolt the safety cage hoop adapters together and attach to the
safety cage hoop halves. Be sure to use the 5/16" x 3/4" bolt with the head of the bolt to the inside of the
safety cage. Bolt these assemblies to the safety cage brackets and hoop adjuster plates. (See connection
detail
on Page 90 for proper hole location.) Tighten bolts as you go. The bottom assembly requires two (2)
hoop halves and will be positioned just below the platform as shown in Figure 8K . Use the safety cage
hoop adjuster angle to secure the two (2) hoop half assemblies to the vertical entrance angle on the
platform assembly.
Figure 8K
NOTE: 48" Vertical supports removed in Figure 8K for clarity.
67-1/2" Extension angles (LS-6775)
(See extension angle hole detail
on
Page 15 for proper installation.)