Grain Systems Bin Accessories PNEG-1451 - Manual (Page 92)

8. 4.00" Corrugation Farm Commercial Hopper Tank (FCHT) 7-9 Rings
92 PNEG-1451 Ladder, Safety Cage and Platform for Hopper Tanks
24"-48" Safety Cage Bell Sections
Attach the vertical supports to the hoop half assembly from the final safety cage installation using
5/16" x 3/4" bolts and nuts (with the heads on the inside of the cage). Assemble the special bell safety
cage hoop halves and attach to other end of vertical supports. The vertical support must be bent at the
flat area to allow for the angle of the bell section. Attach the safety cage brackets to the ladder as shown
in the general detail information
on Page 12 . Once the safety cage brackets are installed, attach the bell
safety cage hoop half assembly to the safety cage brackets and tighten bolts.
NOTE: The safety cage bell section is to be used at the point of termination of the safety cage and should
be just above the base platform (generally 7' to 8').
Figure 8P 24" Bell
Figure 8Q 48" Bell