Pulley assembly – Grain Systems PNEG-1510 User Manual
Page 57
Advertising
9. Assembly
PNEG-1510 Top Dry 24', 30' and 36' Manual Batch
57
Pulley Assembly
Finish assembling the center collar by adding the cross channel. Position the pulley assembly to the cross
channel in the middle of the center collar assembly. Use a 3/8" x 1" hex head cap bolt to fasten assembly
to the cross channel. Position the pulley in the direction of the desired winch location on the sidewall.
Figure 9D
Field drill five (5) 3/8" diameter holes as shown
at left.
Attach the pulley assembly with 5/16" x 3/4" bolts
with the neoprene on the inside of the bin.
Figure 9E
Advertising