Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-720-G2 User Manual
Page 24
4. General Product Information
24
PNEG-720-G2 12" and 16" Series II Sweep
To Remove
1. Remove all cap screws.
2. Insert the cap screws into the threaded jack hole or holes.
3. Tighten all the jackscrews alternately and evenly beginning with the screw farthest from the bushing
saw slot. Tighten until the bushing grip is released. Slide the unit off the shaft.
Do not lubricate the bushing taper, bushing bore, hub taper or the shaft. Doing so
could result in breakage of the product.
Excessive screw torque may cause damage to either the bushing and/or the
sheave. Uneven pressure on the jackscrews may also damage the bushing flange
making removal difficult without damage to the bushing and/or sheave.
Do not use worn hex keys and/or wrenches. Doing so may result in a loose
assembly or may damage the screws.
CAUTION