Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-720-G2 - Manual (Page 52)

5. Assembly
52 PNEG-720-G2 12" and 16" Series II Sweep
Center Pivot Installation
NOTE: If you are only running the cords across the floor, you may skip Step A and go to Step B on Page 55 .
A. Center Pivot with Pivot Kit
1. Use the pivot assembly supplied with the sweep pivot kit and cut it to fit, if needed.
2. Feed the multi-conductor cord through the hole in the back of the sweep head section leaving five
feet (5') of cord outside the hole. (See Figure 5AJ.)
Figure 5AJ
3. Feed the power cord through the pivot tube. (See Figure 5AK on Page 53.)
4. Align the hole in the backshield with the pivot tube and push the sweep onto the pivot tube.
(See Figure 5AK on Page 53.)
5. Connect the pivot plate to the backshield using two (2) 1/2"-13 x 1-3/4" hex bolts, flat washers,
lock washers and hex nuts. (See Figure 5AK on Page 53.)
6. Fasten the pivot rod to the backshield and pivot plate using two (2) 1/2"-13 x 2" hex bolts,
lock washers and hex nuts. (See Figure 5AK on Page 53.)
CAUTION
The center pipe of the pivot assembly MUST be in the center of the bin. If it is
not, the sweep could hit the bin wall.