Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-720-G2 User Manual
Page 43
Advertising
5. Assembly
PNEG-720-G2 12" and 16" Series II Sweep
43
D. Slide the bushing and small sheave onto the motor shaft with a key.
Figure 5Y
E. Align the sheaves with a straight edge to assure proper alignment and tighten the screws on the
bushings.
F. Carefully install the belts onto the large and small sheaves.
NOTE: Adjust the hex nuts on the motor mount adjustment rod to attain correct belt tension while making
sure the motor mount is level on both rods. The motor mount must be parallel to the auger screw
to allow for proper sheave alignment.
Advertising