Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-720-G2 User Manual
Page 47
5. Assembly
PNEG-720-G2 12" and 16" Series II Sweep
47
H. Feed each of the six (6) 14 AWG stranded wires through the 3/4" rigid conduit assembly and cut
them off, leaving six inches (6") at both the left junction box and drive motor.
I. Feed each of the six (6) 10 AWG stranded wires cord through the 3/4" x 40" liquid tight flex conduit
and cut four (4) of them off, leaving six inches (6") at both the right junction box and auger motor. Cut
the 10 AWG blue and yellow wires longer so they can be connected to the 14 AWG blue and yellow
wires in the left junction box.
J. Place the 3/4" rigid conduit assembly onto the back frame of the sweep between the connecting angle
and connecting flange.
Figure 5AD
K. Fasten the junction boxes to the mounting plate using two (2) 3/8"-16 x 1-3/8" U-bolts, four (4) lock
washers and hex nuts.
Figure 5AE