Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-720-G2 - Manual (Page 30)

5. Assembly
30 PNEG-720-G2 12" and 16" Series II Sweep
Figure 5H
Drive Axle Assembly and Bearing Support
A. Loosen set screws on bearings.
B. Replace standard grease zerks with 90° grease zerks on both bearings. Make sure the 90° grease
zerk is turned as shown in Figure 5I , so the zerks are accessible from the center of the tractor
drive stand.
Figure 5I Figure 5J
C. Slide the axle assembly between the legs of the tractor drive stand as shown in Figure 5J .
D. Rotate the pillow block bearings until the bases are facing up. (See Figure 5J.)
NOTICE
The gear reducer is NOT filled with oil from the factory. For gear reducer
specifications and oil fill recommendations, refer to
Lubrication Section on Page 68
of this manual.