QTECH QSW-8300 Инструкция по настройке - Manual (Page 124)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
123
(4) Configure the relation between VRF instance and the interface
1. Create Layer 3 Interface
Command Explanation
Global Mode
interface vlan <vlan-id>
no interface vlan <vlan-id>
Creates a VLAN interface (VLAN interface is a Layer 3
interface); the no command deletes the VLAN interface
(Layer 3 interface) created in the switch.
interface loopback <loopback-
id>
no interface loopback
<loopback-id>
Creates a Loopback interface then enter the loopback
Port Mode; the no command deletes the Loopback
interface created in the switch.
2. Bandwidth for Layer 3 Interface configuration
3. Configure VLAN interface description
4. Open or close the vlan interface
5. VRF configuration
(1) Create VRF instance and enter VPN view
(2) Configure RD of VRF instance (optional)
(3) Configure RT of VRF instance (optional)
(4) Configure the relation between VRF instance and the interface
Command Explanation
VLAN Interface Mode
bandwidth <bandwidth>
no bandwidth
Configure the bandwidth for Layer 3 Interface.
The no command recovery the default value.
Command Explanation
VLAN Interface Mode
description <text>
no description
Configure the description information of VLAN
interface. The no command will cancel the
description information of VLAN interface.
Command Explanation
VLAN Interface Mode
shutdown
no shutdown
Open or close the vlan interface.