QTECH QSW-8300 Инструкция по настройке - Manual (Page 48)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
47
Customer Service Provider Customer
CE PE
802.1ah OAMPDU
802.3ah
Ethernet in
the First Mile
Typical OAM application topology
8.2 EFM OAM Configuration
EFM OAM configuration task list
1. Enable EFM OAM function of port
2. Configure link monitor
3. Configure remote failure
4. Enable EFM OAM loopback of port
Note: it needs to enable OAM first when configuring OAM parameters.
1. Enable EFM OAM function of port
Command Explanation
Port mode
ethernet-oam mode {active | passive}
Configure work mode of EFM OAM,
default is active mode.
ethernet-oam
no ethernet-oam
Enable EFM OAM of port, no command
disables EFM OAM of port.
ethernet-oam period <seconds>
no ethernet-oam period
Configure transmission period of
OAMPDU (optional), no command
restores the default value.
ethernet-oam timeout <seconds>
no ethernet-oam timeout
Configure timeout of EFM OAM
connection, no command restores the
default value.