QTECH QSW-8300 Инструкция по настройке - Manual (Page 239)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
238
(1) Configure DVMRP Interface Parameters
Configure the delay of transmitting report message on DVMRP interface and the message
number each time it transmits
Configure metric value of DVMRP interface
Configure if DVMRP is able to set up neighbors with DVMRP routers which can not
Prune/Graft
Command Explanation
Interface Configuration Mode
ip dvmrp output-report-delay
<delay_val> [<burst_size>]
no ip dvmrp output-report-delay
Configure the delay of transmitting DVMRP report
message on interface and the message number
each time it transmits, the “no ip dvmrp output-
report-delay
” command restores default value.
ip dvmrp metric <metric_val>
no ip dvmrp metric
Configure interface DVMRP report message metric
value; the “no ip dvmrp metric” command restores
default value.
ip dvmrp reject-non-pruners
no ip dvmrp reject-non-pruners
Configure the interface rejects to set up neighbor
relationship with non pruning/grafting DVMRP
router. The “no ip dvmrp reject-non-pruners”
command restores to being able to set up neighbor
ship.
4. Configure DVMRP Tunnel
Command Explanation
Interface Configuration Mode
ip dvmrp tunnel <index> <src-ip>
<dst-ip>
no ip dvmrp tunnel {<index> |<src-ip>
<dst-ip>}
This command configures a DVMRP tunnel; the
“no ip dvmrp tunnel {<index> |<src-ip> <dst-
ip>} ” command deletes a DVMRP tunnel.
28.7.3 DVMRP Configuration Examples
As shown in the following figure, add the Ethernet interfaces of Switch A and Switch B to
corresponding VLAN, and enable DVMRP on each VLAN interface.