QTECH QSW-8300 Инструкция по настройке - Manual (Page 270)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
269
(2) Configure global PIM-SM6 parameter
1) Configure the switch as a candidate BSR
Command Explanation
Global Configuration Mode
ipv6 pim bsr-candiate {vlan
<vlan_id>|<ifname> | tunnel <1-
50>}[hash-mask-length] [priority]
no Ipv6 pim bsr-candiate {vlan
<vlan_id>|<ifname> | tunnel <1-
50>}[hash-mask-length] [priority]
This command is the global candidate BSR
configuration command, which is used to configure
the information of PIM-SM candidate BSR so that it
can compete for BSR router with other candidate
BSR. The no operation is to cancel the
configuration of BSR.
2) Configure the switch as a candidate RP
Command Explanation
Global Configuration Mode
ipv6 pim rp-candiate {vlan<vlan-id>|
loopback<index>|<ifname>} [<group
range>] [<priority>]
no ipv6 pim rp-candiate
This command is the global candidate RP
configuration command, which is used to configure
the information of PIM-SM candidate RP so that it
can compete for RP router with other candidate RP.
The no operation is to cancel the configuration of
RP.
3) Configure static RP
Command Explanation
Global Configuration Mode
ipv6 pim rp-address <rp-address>
[<group-range>]
no ipv6 pim rp-address <rp-address>
{all|<group-range>}
To configure the address of the candidate RP. The
no form of this command will remove the
configuration for the candidate RP.
4) Configure the cache time of kernel multicast route
Command Explanation
Global Configuration Mode
ipv6 multicast unresolved-cache
aging-time <value>
no ipv6 multicast unresolved-cache
aging-time
Configure the cache time of kernel multicast route,
the no command restores the default value.