QTECH QSW-8300 Инструкция по настройке - Manual (Page 233)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
232
Switch(config)#ip pim anycast-rp
Switch(config)#ip pim anycast-rp self-rp-address 192.168.2.1
Switch(config)#ip pim anycast-rp 1.1.1.1 192.168.3.2
RP2 Configuration:
Switch#config
Switch(config)#interface loopback 1
Switch(Config-if-Loopback1)#ip address 1.1.1.1 255.255.255.255
Switch(Config-if-Loopback1)#exit
Switch(config)#ip pim rp-candidate loopback1
Switch(config)#ip pim multicast-routing
Switch(config)#ip pim anycast-rp
Switch(config)#ip pim anycast-rp self-rp-address 192.168.3.2
Switch(config)#ip pim anycast-rp 1.1.1.1 192.168.2.1
28.5.4 ANYCAST RP Troubleshooting
When configuring and using ANYCAST RP function, the ANYCAST RP might work abnormally
because of faults in physical connections, configurations or something others. So, the users
should pay attention to the following points:
The physical connections should be guaranteed to be correct
The PIM-SM protocol should be guaranteed to operate normally
The ANYCAST RP should be guaranteed to be enabled in Global configuration mode
The self-rp-address should be guaranteed to be configured correctly in Global configuration
mode
The other-rp-address should be guaranteed to be configured correctly in Global configuration
mode
All the interface routers should be guaranteed to be correctly added, including the loopback
interface as a RP
Use “show ip pim anycast rp status” command to check whether the configuration
information of ANYCAST RP is correct
If the problems of ANYCAST still cannot be solved after checking, please use debug
commands like “debug pim anycast-rp”, then copy the DEBUG information within three
minutes and send it to the technical service center of our company.
28.6 PIM-SSM
28.6.1 Introduction to PIM-SSM
Source Specific Multicast (PIM-SSM) is a new kind of multicast service protocol. With PIM-
SSM, a multicast session is distinguished by the multicast group address and multicast source