QTECH QSW-8300 Инструкция по настройке - Manual (Page 132)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
131
(15) Set the flag representing whether the address information will be obtained via DHCPv6
Command Explanation
Interface Configuration Mode
ipv6 nd managed-config-flag
Set the flag representing whether the address
information will be obtained via DHCPv6.
3. IPv6 Tunnel Configuration
(1) Add/Delete tunnel
Command Explanation
Global mode
interface tunnel <tnl-id>
no interface tunnel <tnl-id>
Create a tunnel. The NO command deletes a
tunnel.
(2) Configure tunnel description
Command Explanation
Tunnel Configuration Mode
description <desc>
no description
Configure tunnel description. The NO command
deletes the tunnel description.
(3) Configure tunnel source
Command Explanation
Tunnel Configuration Mode
tunnel source { <ipv4-address> |
<ipv6-address>| <interface-name> }
no tunnel source
Configure tunnel source end IPv4/IPv6 address.
The NO command deletes the IPv4/IPv6 address of
tunnel source end.
(4) Configure Tunnel Destination
Command Explanation
Tunnel Configuration Mode
tunnel destination {<ipv4-address> |
<ipv6-address>}
no tunnel destination
Configure tunnel destination end IPv4/IPv6
address. The NO command deletes the IPv4/IPv6
address of tunnel destination end.
(5) Configure Tunnel Next-Hop
Command Explanation
Tunnel Configuration Mode