1 general information, General information -24 – YSI DIQ/S 182 XT-4-MOD User Manual

Page 38

Advertising
background image

Installation

System 182 XT-4

3 - 24

ba76028e01

02/2012

3.7

Onsite installation of DIQ/S 182 XT-4-MOD and
MIQ modules

3.7.1

General information

The DIQ/S 182 XT-4-MOD and the DIQ and MIQ modules have a
comprehensive program of mounting accessories, which can be used
to adapt the installation to the most varied requirements.

Caution

Components installed outside must always be protected by a sun
shield against the effects of the weather (snow, ice and direct
solar radiation). Otherwise, malfunctions can result. Always
mount the DIQ/S 182 XT-4-MOD vertically. Do not under any
circumstances install MIQ modules without rain protection with
the lid facing upwards (danger of retained humidity and
penetration of moisture).

Caution

No contact base may be mounted on the back of the module
(danger of short-circuit!) if the module is mounted on a wall, a sun
shield, or a top hat rail.

Installation options

The most important types of installation for theDIQ/S 182 XT-4-MOD
are described in the following chapters:

Mounting on a mounting stand with the SSH/IQ sun shield:

The SSH/IQ sun shield provides enough space for the DIQ/
S 182 XT-4-MOD
and two MIQ modules (section 3.7.2).

Mounting on the SD/K 170 sun shield

The SD/K 170 sun shield provides room for the DIQ/S 182 XT-4-
MOD
. The sun shield can be mounted on round or square section
pipes (e.g. rails) with the aid of the MR/SD 170 mounting kit
(section 3.7.3).

Wall mounting:

The DIQ/S 182 XT-4-MOD or MIQ module is permanently screwed
to a wall. For wall mounting, use the WMS/IQ mounting set (see
chapter 12 A

CCESSORIES

AND

OPTIONS

).

Panel mounting:

The DIQ/S 182 XT-4-MOD or the MIQ module is installed in the
aperture of a panel. The dimensions of the aperture are
138 x 138 mm + 1 mm. The panel may not be thicker than 15 mm
(section 3.7.3).

Top hat rail mounting:

The DIQ/S 182 XT-4-MOD or the MIQ module is mounted on a
35 mm top hat rail with the aid of a bracket, e.g. in a control cabinet.
The connection can be released again with one simple movement
(section 3.7.4).

Advertising