YSI DIQ/S 182 XT-4-MOD - Manual (Page 136)

What to do if ... System 182 XT-4
9 - 4 ba76028e01 02/2012
Note
It is always possible to replace components and assign a substitute if
the software state of the substitute component is as high as or higher
than the software version of the original component. Otherwise the
component may not be accepted as a substitute component by the
DIQ/S 182 XT-4-MOD.
Case 2:
The type of sensor is identical
with the type of sensor in an
inactive dataset (or several
inactive datasets), but the serial
numbers differ. Operator intervention is required
here. The connected IQ sensor
can:
– be assigned to the inactive
dataset (or one of the inactive
datasets).
Example: Replacing an
IQ sensor.
Make sure that the substitute
sensor has at least the
software status of the inactive
IQ sensor.
– be included as a new module
in the list of the sensors.
The operating sequence to do
this is described below.