YSI DIQ/S 182 XT-4-MOD - Manual (Page 43)

System 182 XT-4 Installation
3 - 29 ba76028e01 02/2012
Fig. 3-20 Mounting DIQ/S 182 Universal Transmitter in switch panel
3 Slightly unscrew the screws (pos. 2 and 3) of the two angle
brackets (pos. 1 in Fig. 3-20), but do not remove them.
4 Push in the two angle brackets - as shown in Fig. 3-20 - into
the lateral guides of the Universal Transmitter up to the stop.
5 Tighten the screws (pos. 2).
6 Screw in the screws (pos. 3) until the screws rest snugly
against the panel.
7 Screw the DIQ/CR3 combi output module onto the DIQ/S 182
Universal Transmitter.
Fo r s tack m
oun
ting rem
ove lab el
an d insta
ll co ntact carrie
r
1
2
3
3
2