YSI DIQ/S 182 XT-4-MOD - Manual (Page 123)

System 182 XT-4 Modbus connection
7 - 7 ba76028e01 02/2012
Changing the
assignment of sensor
numbers
You want to change the assignment of sensor numbers to sensors in
an already running IQ S
ENSOR N ET system.
Note
When the inactive datasets are deleted, all settings for the sensors are
deleted as well.
Creating the identical
assignment of sensor
numbers in several
systems
You want to install several identical IQ S ENSOR N ET systems and, at
the same time, create the same sequence of sensor number
assignments to the sensors in all systems.
1 Unplug all sensors from the IQ S ENSOR N ET .
2 Delete all inactive datasets in the list of sensors (see System
operating manual, chapter Deleting inactive datasets of
sensors).
3 Connect the sensors to the system in the required order. For
each sensor, wait until the sensor is recognized by the system
(see System operating manual, chapter Installation).
1 Carry out a system start without any sensors (see System
operating manual, chapter Installation).
2 Connect the sensors to the system in the required order. For
each sensor, wait until the sensor is recognized by the system
(see System operating manual, chapter Installation).
3 Repeat steps 1 and 2 for all other systems and, while doing so,
keep to exactly the same order when connecting the sensors.