YSI DIQ/S 182 XT-4-MOD - Manual (Page 94)

Relay outputs System 182 XT-4
6 - 4 ba76028e01 02/2012
6.2.3 Setting outputs
Procedure: Setting an
output
Note
To accept all settings, highlight the
Save and quit menu item at the lower end of the setting table and press
g
. If you exit the setting table via
m
,
e
/Quit or the Quit menu item,
all changes are ignored.
1 Open the SETTINGS menu with
s
.
2 Using
w
and
g
, select and confirm the Relay output Rx
menu item (corresponding to sensor 1, 2 or 3).
3 Confirm the selection Set output with
g
.
The setting table of the output is displayed.
4 Edit the setting table as described in section 4.3.2.