3 setting the modbus interface parameters, Setting the modbus interface parameters -4, Proceeding, see section 7.3 – YSI DIQ/S 182 XT-4-MOD User Manual
Page 120
Advertising
Modbus connection
System 182 XT-4
7 - 4
ba76028e01
02/2012
Note
Please observe the operating manual of the connector.
7.3
Setting the Modbus interface parameters
The setting of the Modbus interface parameters (RS 485 interface) is
done in the menu, MODBUS configuration.
Settings
Proceeding:
setting the interface
parameters
Setting
Selection/Values
Explanation
Device Address
1 ... 247
Device address of
the DIQ/S 182 XT-
4-MOD
Baud rate
1200
2400
4800
9600
19200
38400
57600
Baud rate
Parity
None
Even
Odd
Parity
None
(2 stop bits)
Even
(1 stop bit)
Odd
(1 stop bit)
1
Open the SETTINGS menu with
s
.
2
Select and confirm the MODBUS configuration menu item with
w
and
g
.
3
Edit the setting table as described in section 4.3.2.
Advertising