YSI DIQ/S 182 XT-4-MOD - Manual (Page 24)

Installation System 182 XT-4
3 - 10 ba76028e01 02/2012
3.6 Connecting system components
3.6.1 Connecting MIQ modules: General information
You can connect the DIQ/S 182 XT-4 with MIQ modules without
connecting cable (stacking). According to the same principle
MIQ modules can also be connected with one another.
Mounting direction Variant 1 - stack expansion
forwards.
The DIQ/S 182 XT-4-MOD or an
MIQ module is attached by its
back to the lid of an MIQ module
(from page 3-12).
Select this variant if an
MIQ module is already
permanently installed, e.g. to a
wall.
Variant 2: - stack expansion
backwards.
An MIQ module is attached with
its lid to the back of the DIQ/
S 182 XT-4-MOD or another
MIQ module (page 3-15).
Select this variant if the DIQ/
S 182 XT-4-MOD or the front
MIQ module is already
permanently installed, e.g. in a
panel.
MIQ Module
MIQ Module
DIQ/S 184 XT-4-PR
MIQ Module
MIQ Module
MIQ Module
DIQ/S 184 XT-4-PR
MIQ Module