YSI DIQ/S 182 XT-4-MOD - Manual (Page 118)

Modbus connection System 182 XT-4
7 - 2 ba76028e01 02/2012
7.2 Connecting the Modbus cable
The Modbus cable is connected to the DIQ/S 182 XT-4-MOD using a
9-pin D-SUB connector on the top of the housing. As connector on the
cable side, we exclusively recommend one of the following two
connectors.
Manufacturer: Phoenix Contact GmbH & Co. KG
Flachsmarkt 8
32825 Blomberg
Germany
http://www.phoenixcontact.com
Types: VS-09-PROFB-SC
(Phoenix article no. 1654549, with screwed contacts,
available from YSI under order number 902 888Y)
or: VS-09-PROFB-SP
(Phoenix article no. 1654345, with spring contacts)
To remove the blind plug, lift the safety bracket at both clamps at the
left and right side using a suitable screw driver (see Fig. 7-1).
Fig. 7-1 Removing the safety bracket
Caution
To prevent the enclosure of the DIQ/S 182 XT-4-MOD from being
penetrated by water the following must be observed:
 Use connectors recommended by YSI only.
 When the plug connector is removed, the connector socket of
the DIQ/S 182 XT-4-MOD must be closed with the blind plug and
secured with the safety bracket.
Safety bracket