YSI DIQ/S 182 XT-4-MOD - Manual (Page 87)

System 182 XT-4 The SETTINGS menu
5 - 3 ba76028e01 02/2012
Procedure:
Carrying out settings
Note
To accept all settings, highlight the Save and quit menu item at the
lower end of the setting table and press
g
. If you exit the setting table
via
m
,
e
/Quit or the Quit menu item, all changes are ignored.
Inactive sensor datasets An inactive dataset for an IQ sensor arises if the DIQ/S 182 XT-4-MOD
receives no signals from an IQ sensor that is already registered. The
Error display appears on the measured value display instead of a
measured value.
An inactive dataset can be reactivated by assigning it to, for example,
an IQ sensor of the same type (see section 9.3.2). All settings are
retained. If these data are no longer required, they can be erased. All
the settings belonging to this IQ sensor as well as any links with outputs
are deleted by this action.
5 Open the SETTINGS menu with
s
.
6 Using
w
and
g
select and confirm the S0x Sensor menu
item (corresponding to the sensor number).
The following note appears:
If the measuring mode or measuring range is changed, the
links of the sensor are erased. .
7 If you want to continue, press
g
.
The setting table of the sensor is displayed.
8 Edit the setting table as described in section 4.3.2.