Clear-Com HX System Frames - Manual (Page 35)

4. From the Setup menu, select the Serial port… entry.
Figure 14: Tera Term: selecting Serial port…
5. The Serial port configuration dialog is displayed. Configure the serial port as follows:
Field Data (to enter / select)
Port Com1
Note:
Change as required to match a COM port on the PC.
Baud Rate 115200
Parity Even
Stop One (bits)
Data 8 (bits)
Table 9: Tera Term: Serial port configuration
Tip: You can use the Tera Term application for many of the Eclipse HX system upgrade
processes. To save and recall the relevant com port settings in Tera Term, select the
Setup / Save or Restore settings options.
6. Connect the PC serial port to the RS232 port on the rear of the Eclipse HX-Median / Eclipse
HX-Omega / Eclipse HX-Delta matrix, using the RS232 cable.
7. Remove both CPU cards from the matrix. Power on the Eclipse HX-Median / Eclipse HX-
Omega / Eclipse HX-Delta matrix.
28 Eclipse HX Upgrade Guide