Clear-Com HX System Frames User Manual

Page 70

Advertising
background image

8. Upgrade / program the second of the two H8 devices:

a. Connect the MVX serial cable (

CAB-MVX-48Z) between the COM port on the PC and

J11 (H8FP2) on the MVX card.

Note:

The MVX connection is polarized to ensure correct connection.

b. On the MVX card, ensure that jumper H8 Boot2 (JP10) is made.

c. Select Program Flash from the Flash Development Toolkit (FDT) program.

d. Confirm that FDT reports the image has been written successfully.

e. Remove the serial cable.

f.

Remove jumper JP10.

For the location of connectors, jumpers and reset switch positions on the Eclipse HX-PiCo,
see Figure 40: Eclipse HX-PiCo main board.

Important note:

If the MVX card fails to upgrade, press the Reset button, located near the H8FP1 (JP11)
connector and select Program Flash from the FDT again.

If you are using a USB-to-serial adaptor, the adaptor may have to be unplugged and re-
plugged to enable the upgrade to start on some computers. If you are running the EHX
application, ensure that EHX is configured for Ethernet and not serial connection.

63

Eclipse HX Upgrade Guide

Advertising
This manual is related to the following products: