Clear-Com HX System Frames - Manual (Page 81)

MVX-A16 serial upgrade cable
(Clear-Com part CAB-MVX-48Z) For an image of this cable, see
Figure 28: MVX-A16 Serial upgrade cable.
The appropriate MVX code file
(*.fwc format for the separate
MVX boot file, *.mot format for
the combined MVX boot and
application code file )
You can find the Eclipse HX-PiCo MVX code files on the
Eclipse HX v7.5 software DVD:
Software DVD > Eclipse HX-Omega-Median-Delta >
xxxxxxZ-MVX Boot
Software DVD > Eclipse HX-Omega-Median-Delta >
xxxxxxZ-MVX Combined Boot & Application
Where xxxxxxZ represents the product number.
Table 22: Required equipment
2. Install the Renesas Flash Development Toolkit 3.4 Basic (FDT). Accept the default install
settings.
3. Start the Renesas Flash Development Toolkit 3.4 (FDT) from Programs, selecting the basic
Startup option.
4. Access the configuration (settings) dialogs, by selecting Options > New Settings...
Configure the FDT, as shown in the table below:
Settings dialog / option Setting to enter
Select Device
H8S/2318F
Select Port COM1 (Change to match a COM port present on the PC)
CPU Frequency 20.0000 Mhz
Connection Boot mode
Recommended Speed 38400 (Deselect the Use-Default option)
Protection Automatic
Messaging Advanced
User Area Selected (Checked)
Table 23: FDT settings
Note:
The first time the FDT is run, the settings dialogs are displayed by default. After the FDT has
been configured, the settings dialogs are no longer shown by default.
Tip: For more information about installing and configuring the Renesas FDT, see
Appendix D: Hitachi Renesas Flash Development Tool.
74 Eclipse HX Upgrade Guide