Clear-Com HX System Frames - Manual (Page 96)

11. Connect the MVX serial cable
(CAB-MVX-48Z) between the PC serial port and the E-QUE
card CON-200.
Reinsert the E-QUE card into the rack.
Figure 58: E-QUE MK1 card serial connector
12. If it is not already powered up, power up the Eclipse HX-Median / Eclipse HX-Omega /
Eclipse HX-Delta matrix.
13. Ensure that the E-QUE card and the PC are both connected to the Ethernet network in some
way, or are connected using a crossover Ethernet cable.
The LAN connector on the E-QUE card is the highest RJ-45 socket on the back panel. When
the E-QUE card is connected to the PC or to the network, check that the LAN LEDs (the
yellow and green lights at the bottom of the card) are flashing occasionally, indicating a
network connection.
89 Eclipse HX Upgrade Guide