Hach-Lange SI794 I User Manual - Manual (Page 32)

32
Overview of configuration steps
Selection / Default
2200 SIE, 8398 PM, 3700 GLI, other
xx.xxx c
8 kHz / 12 kHz
mS/cm, S/m, Conc, SAL
NaCl, HCl, NaOH, H
2
SO
4
, HNO
3
(Code 01 ... 10. see Pg 113 et seq.)
Select current range 0-20 mA / 4-20 mA
Characteristic (not for Conc, SAL) Linear LIN / Logarithmic LOG
Time averaging filter xxxx SEC
out2 Output 2
o2 . Select temperature unit °C / °F
Select current range 0-20 mA / 4-20 mA
Enter current start xxx.x
Enter current end xxx.x
Time averaging filter xxxx SEC
22 mA signal for temp error ON / OFF
Signal response during HOLD Last / Fix
xxx.x mA
22 mA signal for error messages ON / OFF
Menu Code
out1 Output 1
o1 . Sensor selection *
Enter transfer ratio
Select process variable
Select solution (Conc)
Signal response during HOLD Last / Fix
Enter fixed value xxx.x mA
xxx.xx
Entry of cell factor
Select measuring frequency
Select temperature probe Pt100/Pt1000/NTC100
LIN: xxxx mS Enter current start
Enter current end
LOG: Enter current start
Enter current end
xxxx mS
in decades: 0.001 ... 1000
in decades: 0.001 ... 1000
other*:
Enter fixed value Fix:
Fix: