Hach-Lange SI794 I User Manual - Manual (Page 35)

35 35
tc Temperature compensation
tc . Temp compensation selection OFF / Lin / nLF
Lin: Enter temperature coefficient xx.xx %/K
Menu Code Selection / Default
ALrt Alarm settings
AL . Select Sensocheck ON / OFF
Enter alarm delay xxxx sec
LED in Hold mode ON / OFF
rLAY
rL . Select limit function / controller LiMIT / CtROL
Select contact function Lo / Hi L1 .
Select contact response N/O / N/C
Enter setpoint xxxx
Enter hysteresis xxxx
Enter delay xxxx SEC
Select contact function Lo / Hi L2 .
Enter neutral zone xxxx
(P) Controller gain K
P
xxxx %
(I) Reset time T
R
xxxx SEC
(D) Rate time T
D
xxxx SEC
Pulse length / pulse frequency PLC / PFC
PLC: Pulse length xxxx SEC
PFC: Pulse frequency xxxx /min
Select HOLD response Y Last / Y Off
rinse / PSEt 2
Rinsing interval xxx.x h rinse
Rinse time xxxx SEC
Contact response N/O / N/C
Enter controller setpoint xxxx Ct .
Select contact response N/O / N/C
Enter setpoint xxxx
Enter hysteresis xxxx
Enter delay xxxx SEC
Relay 1/2: Limit values, controller
(Select cleaning / signal/ parameter set)*
Contact CLEAN / PSet2 Cln
Cn .
*) These parameters are only edited in parameter set 1.
They are valid for both parameter sets.