Hach-Lange SI794 I User Manual - Manual (Page 75)

75
Code . Parameter Setting
P1 (conf 1200) P2 (conf 1288)
rL. Relay function ____________ ____________
L1. Contact function ____________ ____________
L1. Contact response ____________ ____________
L1. Setpoint ____________ ____________
L1. Hysteresis ____________ ____________
L1. Delay ____________ ____________
L2. Contact function ____________ ____________
L2. Contact response ____________ ____________
L2. Setpoint ____________ ____________
L2. Hysteresis ____________ ____________
L2. Delay ____________ ____________
Ct. Setpoint ____________ ____________
Ct. Neutral zone ____________ ____________
Ct. P action ____________ ____________
Ct. I action ____________ ____________
Ct. D action ____________ ____________
Ct. PLC/PFC controller ____________ ____________
Ct. Pulse length ____________ ____________
Ct. Pulse frequency ____________ ____________
Ct. HOLD response ____________ ____________
Cn Rinse / PSet2 ____________ *
Cn Rinsing interval ____________ *
Cn Rinse duration ____________ *
Cn Contact response ____________ *
*) These parameters are only edited in parameter set 1.
They are valid for both parameter sets.