Hach-Lange SI794 I User Manual - Manual (Page 68)

68
Configuration
Controlling a rinsing probe or
Signaling parameter set 1/2
Select CLEAN / PSet2
Rinsing interval
Rinse time
Contact response
Contact:
CLEAN / PSet2
Cn .
Code Display Menu group Select menu item
rinse
(rinse /
PSet2)
For PSet2:
see next
page
Code Display Action (rinsing probe) Choices
Cn . Function selection*:
• Control of rinsing probe (rinse)
• Signaling active parameter set 2
Select using 4, press enter to
proceed.
000 .0 h
(xxx.x h)
Rinsing interval *
Select using 4, edit number
using5, press enter to proceed.
Rinse duration *
Select using 4, edit number
using5, press enter to proceed.
0060 sec
(xxxx sec)
Select contact response*
N/O: normally open contact
N/C: normally closed contact
Select using 4, press enter to
proceed
N/O
( N/O
N/C)
rinse
*) These parameters are only edited in parameter set 1.
They are valid for both parameter sets.