Hach-Lange SI794 I User Manual - Manual (Page 74)

74
Code . Parameter Setting
P1 (conf 1200) P2 (conf 1288)
o1. Sensor ____________ *
o1. Process variable ____________ ____________
o1. Solution (Conc) ____________ ____________
o1. 0/4-20 mA ____________ ____________
o1. Characteristic (LIN/LOG) ____________ ____________
o1. Current start (LIN) ____________ ____________
o1. Current end (LIN) ____________ ____________
o1. Current start (LOG) ____________ ____________
o1. Current end (LOG) ____________ ____________
o1. Filter time ____________ ____________
o1. 22mA signal ____________ ____________
o1. HOLD response ____________ ____________
o1. Fix current ____________ ____________
o2. Unit °C / °F ____________ ____________
o2. Temp probe ____________ *
o2. 0/4 ...20mA ____________ ____________
o2. Current start ____________ ____________
o2. Current end ____________ ____________
o2. Filter time ____________ ____________
o2. 22mA signal ____________ ____________
o2. HOLD response ____________ ____________
o2. Fix current ____________ ____________
tc. Temp compensation ____________ ____________
tc. Temp coefficient ____________ ____________
AL. Sensocheck ____________ ____________
AL. Alarm delay ____________ ____________
AL. LED Hold ____________ ____________
Parameter set, individual settings