Hach-Lange EVITA OXY Basic User Manual - Manual (Page 102)

English 102
USC 7000 multidrop system
Change transmitter address
So that the USC 7000 can detect the transmitter via the HART
® bus, a
clear address value between 1 and 15 must be assigned to the
transmitter. The transmitter EVITA
® OXY is supplied with the default
setting 0, which is used for point-to-point installations (USC 5000).
For the programming of the address of a new transmitter connect this to
the USC 7000 and select with the keys of the USC the menu item "Scan
HART bus" (
Figure 21, page 102 .) The next available address between
1 and 15 is assigned to the new transmitter.
Note: If before the access to the HART ® bus an OXY transmitter with an
address value that is over 0 has been registered as interrupted for longer
than two minutes, this address is assigned to the new OXY transmitter.
Figure 21 Transmitter address
Setup of the oxygen- and temperature units and of the
current output of the transmitter
If required the default settings can be changed as shown below.
The setup of the display- and current output for oxygen- and
temperature measurement device is done via "Basic Settings". The
setup of the transmitter measurement range for the oxygen content is
done via change of the values 4 mA and 20 mA.
Otherwise the setup of the measurement range of the oxygen- and
temperature measurement unit is done as shown in
Figure 23, page 103
and in Figure 24, page 104 .
Figure 22 Transmitter settings
Rem. lifetime
Transmitter 0
72. h
No. of alarms
Transmitter 0
12. d
Calibration
Transmitter 0
42. d
Temperature
Transmitter 0
Oxygen
Transmitter 0
10.64 mg/l
Error pending
Scan HART bus
Password
0000.
Settings
USC
Basic settings
TR. 0
Advanced settings
TR. 0
Settings OXY
Ser.No. SSSSVVNUUÅ
TR. 0
Set transmitter
address 00
TR. 0
081R9302.02.02
Reset lifetime
Transmitter 0
Last calibration
Transmitter 0
USC
Scan HART bus
Are you sure ?
USC
Scan HART bus
Busy
USC
Trm. address 0
changed to 05