Hach-Lange BUHLER 2000 Water sampler - Manual (Page 31)

Operation
Page 31 Manual BÜHLER 2000/1029
1.1.8
**********************
SETUP
**********************
SETUP
Enter general settings like
• Date, time
• Language
• Modem
• System settings
1.1.9
**********************
MEMORY
**********************
MEMORY
Here you can display or delete stored information like:
• Info memory (sampling protocol)
• Bottle memory
• Analogue signal
1.1.10
**********************
SERVICE MENU
**********************
SERVICE MENU
In the service menu the single components and the inputs can be
tested. However, modifications should only be carried out by
specially trained service personnel.
CHANGE PROGRAM
1.1.5
**********************
PROGRAM NO. 1
*CHANGE
DELAYED START
START
**********************
A program (No. 01-06) selected in menu 1.1.4 can be
• started immediately
• started with a delay or
• changed.
2.2.1
**********************
PASSWORD
****
**********************
To avoid manipulations to programs, a password has to be entered
first. The factory-set password is „6299“.
Remark: This is only required if a password has been activated
in „Setup“-> „System
settings“. If not, just press the ENT key and you will
get to the next menu!
(If you enter your own password, we recommend to note it down in
the manual as otherwise there is no more access!)
3.4.1
**********************
MODE
EVENT
*TIME
FLOW ANAL. 0-20 mA
**********************
TIME-related sampling
By pressing the ENT key, the time-proportional sampling mode is
selected.