Hach-Lange BUHLER 2000 Water sampler - Manual (Page 34)

Operation
Page 34 Manual Bühler 2000/1029
5.2.12
**********************
REPEAT PROGRAM?
YES
*NO
**********************
Selecting „YES“ means continuous operation (the program is
always restarted).
Remark: In that case, the program will run endlessly. So,
please make sure that the bottles are emptied regularly
according to the programming as otherwise they will be
overfilled.
START PROGRAM
1.1.5
**********************
PROGRAM NO. 1
CHANGE
DELAYED START
*START
**********************
START
After having pressed the ENT key, move the flashing
cursor on „START“ and confirm again with the ENT key. The
program is started immediately.
2.3.1
**********************
DELAYED START
01.01.2009
17:15
**********************
DELAYED START
Enter date and time of the delayed program start.
After having pressed the ENT key, the display shows the delayed
start time. The program will be activated automatically at the
entered date/time.
3.3.1
**********************
PROGRAM NO. 1
START 01.01./17:28
BOTTLE 1
< PAUSE WITH ENT >
**********************
After the program has been started successfully, the following is
shown on the display:
1. The selected program
2. Start with date and time
3. The current bottle (or at special programs also e.g. pulse counter
and number of extracted samples)
The possibility to interrupt the program with ENT (pause mode).
Remark: During an active program you can have
displayed a lot of helpful information without
disturbing the program flow or stopping the
running program. You can scroll through the
menus described in the following with the
up/down arrow keys.
3.3.2
**********************
01.01.2009 17:28:17
NEXT SAMPLE 5:43
NEXT BOTTLE 1:59
FLOW
12.2 mA
**********************
If the „down“ arrow key is pressed, date and time, time of the next
sample extraction and time of the next bottle change are displayed.
In time-proportional programs: display in min.
In flow analogue programs: display in %
In flow digital programs: display in pulses.
The flow can be displayed in L/s, cbm/h or mA (to be set in the
menu SETUP).