Hach-Lange BUHLER 2000 Water sampler - Manual (Page 65)

Warranty and liability
Page 65 Manual Bühler 2000/1029
Warranty and liability
The manufacturer warrants that the product supplied is free of material and
manufacturing defects and undertakes the obligation to repair or replace any defective
parts at zero cost.
The warranty period for instruments is 24 months. If a service contract is taken out within
6 months of purchase, the warranty period is extended to 60 months.
With the exclusion of the further claims, the supplier is liable for defects including the lack
of assured properties as follows: all those parts that, within the warranty period calculated
from the day of the transfer of risk, can be demonstrated to have become unusable or
that can only be used with significant limitations due to a situation present prior to the
transfer of risk, in particular due to incorrect design, poor materials or inadequate finish
will be improved or replaced, at the supplier's discretion. The identification of such
defects must be notified to the supplier in writing without delay, however at the latest 7
days after the identification of the fault. If the customer fails to notify the supplier, the
product is considered approved despite the defect. Further liability for any direct or
indirect damages is not accepted.
If instrument-specific maintenance and servicing work defined by the supplier is to be
performed within the warranty period by the customer (maintenance) or by the supplier
(servicing) and these requirements are not met, claims for damages due to the failure to
comply with the requirements are rendered void. Any further claims, in particular claims
for consequential damages cannot be made.
Consumables and damage caused by improper handling, poor installation or incorrect
use are excluded from this clause.
The manufacturer process instruments are of proven reliability in many applications and
are therefore often used in automatic control loops to provide the most economical
possible operation of the related process.
To avoid or limit consequential damage, it is therefore recommended to design the
control loop such that a malfunction in an instrument results in an automatic change over
to the backup control system; this is the safest operating state for the environment
and the process.
Immunity
This equipment was tested for Industrial level EMC per:
EN 61000-6-2 (EMC Requirements for Electrical Equipment for
Measurement, Control and Laboratory Use) per 2004/108/EEC
EMC: Supporting test records by Hach Company, certified
compliance by Hach Company.
Standards include:
IEC 1000-4-2:08.02 (EN 61000-4-2:08.02) Electrostatic Discharge
Immunity (Criteria B)
IEC 1000-4-3:12.06 (EN 61000-4-3:12.06) Radiated RF
Electromagnetic Field Immunity (Criteria A).
Emissions
This equipment was tested for Radio Frequency Emissions as
follows:
Per 2004/108/EEC EMC: EN 61000-6-4:08.05 (Electrical Equipment for
measurement, control and laboratory use—EMC requirements)
Class “A” emission limits.
Supporting test records by Hach Company, certified
compliance by Hach Company.
Additional Emissions Standard/s include:
EN 55011:08.03 (CISPR 11), Class “A” emission limits