IAI America MSEP - Manual (Page 90)

3.2 Initial Setting
82
[Step 12] For PIO Type, proceed to Step 13.
The parameters input to MSEP are listed as shown below. Indicate the node address
(station) of MSEP on field network in Address.
Caution for CC-Link Type station setting
In the following slave, set the value the number of occupied station is added to the
current station number.

[Step 13] Set the number of axes (two axes in unit) used in each operation mode. If the system is
used in Positioner Modes 1 to 3, Simple Direct Mode or Positioning Mode, input the total
number of the axes in 1) in the figure below. Input the total number of axes in 2) if using in
SEP I/O Mode. Note that 1) and 2) cannot be used at the same time.


1) 2)