IAI America RCM-E - Manual (Page 61)

53
8.10 Software reset after user parameters are changed
For software reset (re-start) function support model (PCON, ACON, ERC2, RCP2, ERC), the screen
moves to the software reset screen when the key is pressed after the user parameter is changed
or the user adjustment is set.
Soft Reset A. 00
* Reset? Y Æ 1 N Æ 0
Press 1 when resetting the software.
(Press 0 when interrupting to reset the software. The
screen returns to the mode select screen.)
The screen moves to the check screen of servo OFF
while servo is ON.
Press 1 when restarting. Since servo OFF is
automatically carried out, it is not necessary to turn
OFF the SON input.
(Press 0 when interrupting to reset the software.)
The screen returns to the mode select screen even if
either one of 1 or 2 is pressed.
Soft Reset A. 00
* Srv OFF? Y Æ 1 N Ж 0