IDEC High Performance Series - Manual (Page 1140)

1 Monitoring with WindO/I-NV2
25-14 WindO/I-NV2 User's Manual
●
Batch Monitor
Displays sequential addresses as a batch.
■ Target
Select MICRO/I or External Devices from the device addresses that include the device addresses to be set.
■ Station No.
Specify the station number of the external device. The range of possible settings can be varies according to the
selected Host I/F drivers.
This option can only be configured when 1:N Communication is selected under Connection in the Select Host I/F
Driver dialog box or the Change Host I/F Driver dialog box.
■ Device Type
Selects the device type.
The list only shows device types that can be used.
■ Address
Specify the address. The range that can be set varies based on the device type selected.
■ Bit
Specify the bit (0 to 15) of the word device when a word device is selected in Device.
■ Length
Specifies the number of device addresses displayed in the list (Bit of the word device specification: 1 to 16, Other than
above: 1 to 1000).
■ Data Type
Selects the data format of the displayed value. For details, refer to Chapter 2 “1.2 Available Data” on page 2-2.
■ (Monitor)
Automatically displays the selected device addresses, in the number specified under Length, from top to bottom,
consecutively.
(Monitor)
Device Address: The specified device addresses are displayed.
toggles between showing and hiding comments. When comments are displayed, click to
display a popup menu, then click Comment and select the check box.