IDEC High Performance Series - Manual (Page 253)

WindO/I-NV2 User’s Manual 5-1
5
Scr
ee
n
This chapter gives an overview of the MICRO/I screen and describes how to create setup and operate the screen.
1.1 Screen Types
The types of screens offered by the MICRO/I and screens that can be created with the WindO/I-NV2 are given below.
1.2 Screen Size
The screen size differs depending on the MICRO/I model selected. The size of the MICRO/I screen is equal the size of
the Base Screen.
*1 The Keypad that is displayed when operating Numerical and Character Input parts when Standard is selected under Type
in the Keypad menu for Numerical and Character Input parts.
Chapter 5
Screen
1 Screen Overview
HG3G HG2G-5F HG2G-5S HG2G-S HG4G HG1F HG2F HG2S HG3F HG4F
Screen Type Screen No. Description
Screens that can
be created with
the WindO/I-NV2
Base Screen 1 to 3000
The screen that is displayed when the MICRO/I is in Run Mode. This
screen places drawing objects and parts on the base and creates a
screen that is displayed on the MICRO/I.
Popup Screen 1 to 3015
The Popup Screen that is displayed on the Base Screen when the
MICRO/I is in Run Mode. The size and coordinates of the screen can be
specified and this screen can also be moved on the Base Screen.
A Popup Screen for the standard Keypad
*1 will automatically be created
in screen numbers 3001 to 3015.
Library Screen –
The screen that registers often used drawing objects and parts to the set
WindO/I-NV2. References the registered screen while the project is being
edited and can copy and appropriate drawing objects and parts from the
screen.
This screen is not included in project data.
The screen
provided by the
MICRO/I
Maintenance
Screen
–
Using the screen that is displayed when the MICRO/I is in Run Mode,
you can switch from Run Mode to System Mode and load a screen to
adjust device monitor and screen brightness.
For details, refer to Chapter 33 “1 Maintenance Screen” on page 33-1.
MICRO/I
1230
0
1
4
7
2
5
8
3
6
9
.
ENT
CLR
CAN
1230
0
1
4
7
2
5
8
3
6
9
.
ENT
CLR
CAN
Maintenance
System Mode
Device Monitor
Adjust Brightness
Maintenance
System Mode
Device Monitor
Adjust Brightness
Base Screen
Popup Screen
Maintenance Screen
Model Screen Size (W x H)
HG1F 300 x 100 dots
HG2G-S/-5S, HG2F/2S 320 x 240 dots
HG2G-5F, HG3F 640 x 480 dots
HG3G/4G, HG4F 800 x 600 dots