IDEC High Performance Series - Manual (Page 125)

WindO/I-NV2 User’s Manual 3-23
5 User Communication
3
Communic
ation
■ Protocol
The command settings for the user communication protocol selected in the Protocol List are displayed.
■ Command
Shows a list of command settings for the selected user communication protocol. Double clicking the line displays the
Data Settings dialog box.
■ Select
The highlighted user communication protocol in the protocol list is selected and Protocol Manager is closed.
■ Close
Close Protocol Manager.
No.: Shows the number for managing command settings. Double clicking the cell displays the Command
Settings dialog box.
Type: Shows the type of command. Double clicking the cell displays the Command Settings dialog box.
Completed: Shows the device for reporting when transmission or receiving of data is successfully completed.
Double clicking the cell displays the Command Settings dialog box.
Status: Shows the destination device for the transmitted or received data size and error information. Double
clicking the cell displays the Command Settings dialog box.
Trigger Type: Shows the trigger type for data transmission or being ready to receive data. Double clicking the cell
displays the Command Settings dialog box.
Condition: Shows the condition of trigger type for data transmission or being ready to receive data. The
displayed content varies based on Trigger Type.
Always Enabled: Trigger conditions are not necessary, so nothing is displayed.
Rising-edge, Falling-edge, While ON, or While OFF:
Shows the bit device as the condition. Double clicking the cell displays the
Command Settings dialog box.
While satisfying the condition or Satisfy the condition:
Shows the conditional expression.
Fixed Period: Shows the period.
Comment: Shows the command comment. Double clicking the cell displays the Command Settings dialog box.
Size: Shows the command data size in bytes. Double clicking the cell displays the Command Settings
dialog box.