IDEC High Performance Series - Manual (Page 737)

WindO/I-NV2 User’s Manual 12-1
12
Commands
This chapter describes how to setup commands and their operation on the MICRO/I.
1.1 How the Bit Write Command is Used
Writes a 0 or 1 to a bit device.
■ Set
■ Reset
■ Momentary
Chapter 12
Commands
1 Bit Write Command
HG3G HG2G-5F HG2G-5S HG2G-S HG4G HG1F HG2F HG2S HG3F HG4F
MICRO/I
Host device
0
1
Condition
Condition
Not satisfied Not satisfied Not satisfied
Satisfied Satisfied Satisfied
Writes a 1 to the specified bit device
when the trigger condition is
satisfied.
1
State of condition
Data written 1
Action Write Write
Condition Condition Condition Condition
Satisfied Satisfied Satisfied Not satisfied Not satisfied Not satisfied Satisfied Satisfied Satisfied Not satisfied Not satisfied Not satisfied
Writes a 0 to the specified bit device
when the trigger condition is
satisfied.
0
State of condition
Data written 0
Action Write Write
Condition Condition Condition Condition
Satisfied Satisfied Satisfied Not satisfied Not satisfied Not satisfied Satisfied Satisfied Satisfied Not satisfied Not satisfied Not satisfied
Writes a 1 to the specified bit device
when the trigger condition is
satisfied.
When the trigger condition is no
longer satisfied, a 0 is written to the
specified bit device.
0
State of condition
Data written 1 0 1
Action Write Write Write Write
Condition Condition Condition Condition
Satisfied Satisfied Satisfied Not satisfied Not satisfied Not satisfied Satisfied Satisfied Satisfied Not satisfied Not satisfied Not satisfied