IDEC High Performance Series - Manual (Page 1303)

WindO/I-NV2 User’s Manual 33-3
2 System Mode Overview
33
MICRO/
I Setup
The System Mode allows you to access the internal MICRO/I initial settings, self diagnosis, and clearing logged data.
In this mode, the project in the MICRO/I will not be running.
2.1 System Mode Screens
In the System mode, the System Menu screen appears (as shown below).
The Top Page and System Menu displays two symbols: Maintenance Cable Status *1 , and Battery Level Status *2 .
■ Maintenance Cable Status
*1 HG2G-S only
*2 HG2G-S/-5S/-5F, HG3G/4G and HG1F only
2 System Mode Overview
HG3G HG2G-5F HG2G-5S HG2G-S HG4G HG1F HG2F HG2S HG3F HG4F
HG2G-S/-5S/-5F, HG3G/4G Top Page HG2G-S/-5S/-5F, HG3G/4G System Menu screen
Press the “Offline” button to display the System Menu
shown in the left figure.
Only the HG2G-5ST22VF-* has the Save button.
HG1F System Menu screen HG2F/2S/3F/4F System Menu screen
Run Simulate Offline
<< >> Save
BRIGHTNESS 31
MAC Address 00:03:7B:F0:12:A8
2010/OCT/14/THU 14:56:44
SYSTEM MODE TOP PAGE
ENG/JPN
For information on accessing the MICRO/I System Mode, refer to “1.2 Displaying the Maintenance Screen”
on page 33-1. Design may change slightly depending on model.
Connected
Disconnected
HG3G HG2G-5F HG2G-5S HG2G-S HG4G HG1F HG2F HG2S HG3F HG4F