IDEC High Performance Series - Manual (Page 243)

WindO/I-NV2 User’s Manual 4-57
3 Project Settings Dialog Box
4
Project Set
tings
3.10 Memory Card Tab
The Memory Card tab is used to configure the destination folder on the memory card inserted in the MICRO/I.
■ Memory Card Folder
Enter the folder name for the folder to use on the MICRO/I within 8 alphanumeric characters using upper-case
alphabetic characters (A to Z) and numbers (0 to 9). The default memory card folder name is “HGDATA01” .
All the data sampled with the log functions is saved in this memory card folder. For details on the memory card, refer
to Chapter 30 “1 Memory Cards” on page 30-1.
■ Remove Files stored in the Memory Card
Select this check box to erase the files saved in the memory card folder.
*1 HG2G-5F, HG3G/4G only
HG3G HG2G-5F HG2G-5S HG2G-S HG4G HG1F HG2F HG2S HG3F HG4F
• You cannot use the following characters in the folder name.
. \ / : * ? “ < > |
• After operation starts, the folders created in the memory card folder and the file names cannot be
changed.
All Screenshot data: Select this check box to erase all the screenshots in the “CAPTURE” folder.
All Alarm Log data: Select this check box to erase all the Alarm Log data saved in folder. The folder name
varies based on the model.
HG2G-5F, HG3G/4G: ALARMLOG
HG2F/3F/4F: ALARM
All Data Log data: Select this check box to erase all the Data Log data saved in folder. The folder name varies
based on the model.
HG2G-5F, HG3G/4G: DATALOG
HG2F/3F/4F: LOG
All Operation Log data *1 : Select this check box to erase all the Operation Log data saved in the “OPERATIONLOG”
folder.
Trigger Device: Specifies the bit device or bit of the word device to serve as condition to delete the files.
Click
to display the Device Address Settings dialog box. For the device address
configuration procedure, refer to Chapter 2 “5.1 Device Address Settings” on page 2-67.