IDEC High Performance Series - Manual (Page 225)

WindO/I-NV2 User’s Manual 4-39
3 Project Settings Dialog Box
4
Project Set
tings
■ Interface Settings
The items that can be configured vary based on the communication interface selected under Interface
Configuration.
When COM1 or COM2 is selected under Interface Configuration
Protocol: Selects the protocol to use with the serial interface COM1 or the serial interface COM2 from the
following.
N/A, Host Communication, O/I Link Master, O/I Link Slave, User Communication 1,
User Communication 2, User Communication 3, Sub Host Communication
Host Communication can only be configured when COM2 is selected for Interface under
Interface Configuration.
This communication interface is not used when N/A is selected.
Baud Rate: Selects the communication speed with the host from the following.
1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200, 187500
The baud rate that can be configured varies based on Protocol.
Data Bits: Selects the data length as 7 or 8.
This option can only be configured when Host Communication, User Communication 1, User
Communication 2, User Communication 3, or Sub Host Communication is selected for
Protocol.
Stop Bits: Selects the stop bits as 1 or 2.
This option can only be configured when Host Communication, User Communication 1, User
Communication 2, User Communication 3, or Sub Host Communication is selected for
Protocol.
Parity: Selects the parity from the following.
None, Odd, Even
This option can only be configured when Host Communication, User Communication 1, User
Communication 2, User Communication 3, or Sub Host Communication is selected for
Protocol.
Flow Control: Selects the flow control method as None or ER according to the host being used.
This option can only be configured when Host Communication or Sub Host Communication is
selected for Protocol.
Serial Interface: Selects the standard for the serial interface to use from the following.
RS232C, RS422/485 2-wire, RS422/485 4-wire
RS422/485 4-wire can only be configured when User Communication 1, User Communication 2,
User Communication 3, or Sub Host Communication is selected for Protocol.
HG3G HG2G-5F HG2G-5S HG2G-S HG4G HG1F HG2F HG2S HG3F HG4F